Natasha's Bathroom

Blog #2 – Natasha’s Bathroom

 

Natasha (not her real name) is a 7-year old girl with Muscular Dystrophy.  Her parents contacted Whiteley & Whiteley, because she was getting older and needed more privacy, including an accessible bathroom, so she could care for herself.  She shared a Jack & Jill bathroom with her sister and the area was cut-up into small spaces; we needed to open it up for the wheelchair.  The diagram below shows the original bathroom layout.

Our plan was to remove the wall between the lavatory area and the toilet/tub area, which provided additional room next to the toilet for accessibility.  We pushed the closet wall back, making the closet two feet deep and adding two feet to the area in front of the lavatory. We now had a five foot turning radius in front of the sink.  Next, we removed the existing vanity and replaced it with one especially designed to accommodate Natasha’s wheelchair.  Finally we widened the doorway from 2’-4” wide to a full 3’-0” and installed a pocket door.  Pocket doors are a good selection, because they slide out of the way, rather than swing through the travel area; however, the hardware used to pull the door closed is recessed into the door and can be difficult for someone with poor manual dexterity to operate.  My personal preference would have been double doors.  Double doors that enclose a 3’-0” opening only swing through 18” each and are easier to reach and open or close.  The diagram below shows the revised bathroom layout.  Note that the door to the sister’s lavatory remains for privacy.

 

These were the structural changes that we made to the bathroom.  Fortunately, in this case, none of the altered walls were load-bearing.  When removing walls, it is important that you consult a professional to ensure that the wall is not load-bearing – a wall that supports the end of a joist.  Removing a load bearing wall without re-designing the load distribution will cause serious structural damage and eventual failure.

Next week, we will discuss the details of Natasha’s vanity design, electrical issues, grab bar options and other unique features designed specifically for Natasha.